Factory resetting a Yealink W52P/W60P
A factory reset of a cordless base will remove all non-factory DECT pairing information. All additional devices including handsets and range extenders will lose DECT pairing with the base during a factory reset. They will need to be reset and repaired as well.
Sometimes there is a configuration issue or other conflict that can be difficult to resolve. In these cases it might be recommended to go back to a known good configuration. This can be accomplished by a factory reset. After a factory reset, the phones will automatically recover their programming (excepting any user made settings such as additional device pairings, ring tones or speed dials). If a factory reset does not resolve the issue, it can be a way of proving a network fault.
Factory resetting a Yealink cordless phone is a simple procedure but must be carried out at the base station:
- Power off the unit - if powered by PoE this might mean unplugging the network cable.
- Wait 15 seconds.
- Press and hold the connect button on the base station.
- Reconnect the power.
- Wait until all 3 status lights are on, showing solid green.
- Release the button and wait 5 minutes.
- Power off the unit.
- Wait 15 seconds.
- Reconnect the power.
- Your phone may update it's configuration after the reboot which may result in a second reboot process automatically within a minute or two of the first reboot.
If the reason for your reboot is related to difficulty in updating your configuration, this step should resolve the issue.
Applies To
Yealink W52P / W52H, Yealink W60P / W56H
Related Articles
Factory resetting a Yealink desk or conference phone
CAUTION - Factory resetting your phone removes all settings and restores your phone to a "like new" configuration. Be sure to back up any settings you require. Only continue if recommended by your support technician or if you have no concerns for ...How do I update configuration / provisioning? [Yealink CP930W DECT Conference Phone]
The CP930W has a different procedure compared with other Yealink wired phones. Related articles are linked below. To update configuration / provisioning on a CP930W: Press the Menu soft key Press 3 for Settings Press 2 for Advanced Enter the PIN ...How to register a handset to the Yealink DECT Base stations.
Registering a Handset with the W60B
How to register a Yealink handset with a single W60B or multiple base stations The following steps may also apply to Yealink models W52B and W80B. With a Single W60B Hold down the Connect button on the base until the top light of the three green ...Rebooting or restarting a desk or conference phone.
Removing the power to reboot can be tricky and could risk dropping the phone or damaging the power connector or the network connector (in the case of PoE power). Rebooting a Yealink phone without this is a simple procedure: Locate the X (or cancel) ...